Jump to content

Search the Community

Showing results for tags 'passive'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Main Board
    • Current
    • The Daily Journal
    • General Discussion
    • Equipment
    • Cameras... love them, hate them
    • Recording Direct to Computer
    • Workflow
    • The Post Place
    • Images of Interest
    • Macs... and the other computer
    • All Things Apple
    • Technical Reference
    • Do It Yourself
    • Manufacturers & Dealers
    • Work Available - Available for Work
    • Post to the Host
  • JWSOUND RESOURCE
    • Donate to Support JWSOUNDGROUP

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests


About

Found 2 results

  1. This a question on Facebook about using passive splitters to feed three receivers in a bag. The user wanted to reduce the number of antennas from 6 to 2 and was questioning whether he would have to amplify the antennas which would complicate the bag setup. My reply for what it is worth: Since you don't need extra range, the small loss in a passive splitter won't hurt your results. Passive splitters may reduce the transmitted RF signal but they also reduce the RF noise in most urban locations by the same amount ,so quite often it is a wash. Getting the antennas up out of the bag will give you extra signal and will probably more than make up for the splitter loss. Also, and I can't emphasize this enough, it will get your antennas away from any RF noise sources in your bag. This could be a very big improvement by itself. Best Regards, Larry Fisher
  2. Hello, I just acquired used passive KRK monitors and a Hafler P3000 amp. I do not know the model number of the monitors, so I have attached a photo of them. I have the following problem: If I turn on the amplifier, with the gain set to minimum, I get a hum, some pops and the drivers of the monitors start moving in and out extremely, which worries me. I immediately turn the amp off again. I have tried searching online for solutions to this problem, which I have personally never encountered. If one of you could help me figure this out, I'd be very grateful. Best, dertras
×
×
  • Create New...