SeeKai Posted October 1, 2014 Report Share Posted October 1, 2014 Hi All, So I was approached about building a 7 pin lemo cable to go between a redrock basestation and a microremote torque motor. My guy wants a thin, flexible cable, which is all well and good - however Redrock inform me that the current draw of the microremote motor can be up to 0.7 amps. I'm pretty sure that rules out using a nice thin 5core AWG33 w/sheild cable from mogami. Anyone got any magic, problem solving knowledge of a 2mm OD 5 core + shield cable stock that is rated for 0.7 amps? Apologies if any of this is gobbledygook - I'm not fully conversant when it comes to cameras. I've been looking online for a while for a suitable cable stock but thought throwing it open to the floor might be acceptable at this point in my search. Thanks all, S. Quote Link to comment Share on other sites More sharing options...
ncg Posted October 1, 2014 Report Share Posted October 1, 2014 Is 2mm the max or is there a different collet available? Quote Link to comment Share on other sites More sharing options...
ncg Posted October 1, 2014 Report Share Posted October 1, 2014 http://www.daburn.com/2708-2714DAFLEXUltra-FlexibleSubminiatureShieldedCable-3.aspx 2710/5 5 conductor, braided shield. 2.24mm OD 30 awg. 30AWG should handle .9 amps un bundled. Hope that helps Good luck Nick Quote Link to comment Share on other sites More sharing options...
SeeKai Posted October 1, 2014 Author Report Share Posted October 1, 2014 That was fast! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.