Matthias Richter Posted April 22, 2015 Report Share Posted April 22, 2015 have updated my TRXs to 9.02 and now when set a single TRX in low power Mode with IFB100 all others audio mutes. Gain stays where set but no audio. RF signal stays. Quote Link to comment Share on other sites More sharing options...
howy Posted April 22, 2015 Report Share Posted April 22, 2015 Do you know what software version was working properly for you? -howy Quote Link to comment Share on other sites More sharing options...
John Blankenship Posted April 22, 2015 Report Share Posted April 22, 2015 Howy, It was great talking tech with you at NAB. You said to follow up with you on this particular issue to help localize the problem, but I've been working steadily since I got home. In my pre-NAB testing, I had to go back a ways to find a version where LOW2 was still working properly. If I can carve some time today, I'll see if I can help narrow it down to a specific version. Quote Link to comment Share on other sites More sharing options...
howy Posted April 22, 2015 Report Share Posted April 22, 2015 I think I found the problem. The new version that should fix it will be 9.12. If you email me I can send you a beta version -howy Quote Link to comment Share on other sites More sharing options...
John Blankenship Posted April 22, 2015 Report Share Posted April 22, 2015 Terrific -- I'll email you when I get back to the studio in a bit. Thanks. Quote Link to comment Share on other sites More sharing options...
Boomboom Posted April 22, 2015 Report Share Posted April 22, 2015 If zaxnet could mute all the *people* at once on a set that'd be great ! Quote Link to comment Share on other sites More sharing options...
Matthias Richter Posted April 22, 2015 Author Report Share Posted April 22, 2015 thanks Howy. I "believe" I came from 8.94 but really not sure. I normally don´t do software changes mid shoot. But since I´m really missing this feature - do you think it´s safe to switch to 9.13? Matthias Quote Link to comment Share on other sites More sharing options...
John Blankenship Posted April 22, 2015 Report Share Posted April 22, 2015 Matthias, I just did a brief test with 9.13 and LOW2 works properly again. I haven't tested it enough to give you a definitive clean bill of health, but it appears to at least work. If you do switch, take a card with a proven version of firmware with you in case of issues. Fortunately, Zaxcom transmitters load firmware quickly. Quote Link to comment Share on other sites More sharing options...
.png.279748a58a2b862b7aa5f3b84126e232.png)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.