Jump to content

DYI Denecke TS2 TS3 Slate Handle


mark kirchner

Recommended Posts

I just finished my DYI slate handle for my Denecke slate. We have had a lot of rain in California so I finally completed the project. I had more time than money! There are additional posts on the topic in Manufactures & Dealers, but I my case this is a DYI project.

Tools used: Drill Press, Drills, Counter Sink Bit, Hacksaw, Files, Tap and Die and a Belt Sander.

Materials used: Scrap Aluminum, 2- Flathead Screws, 2- Roundhead Screws, Sandpaper and Lay-out Fluid.

Note: I did bore 2 small holes to mount the handle to the slate, using the original Denecke hole spacing (not seen in photos).You can see the layout lines and hole spacing/placement in the bottom image.

Mark

IMG_0394.JPG

IMG_0393.JPG

FullSizeRender-2.jpg

FullSizeRender.jpg

Link to comment
Share on other sites

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...