MarkC Posted April 13, 2017 Report Share Posted April 13, 2017 Hello Everyone, I am seeking advice on making a dual purpose cable to connect to the Nagra 4.2 7 pin mixer connector. I have a remote start/stop box and a playback preamplifier output cable. I want to connect both to the mixer connection at the same time. Correct if I am wrong please. If I had a single 7 pin tuchel and connected the remote on/off switch to pins 2 6 7 and a playback cable connected to 5 7 that then went out to two separate female 7 pin tuchels could I run both stop/start and receive an output signal simultaneously? I would be very grateful for your advice. Thank you MarkC Quote Link to comment Share on other sites More sharing options...
JonG Posted April 14, 2017 Report Share Posted April 14, 2017 I want to know too Quote Link to comment Share on other sites More sharing options...
mikewest Posted April 17, 2017 Report Share Posted April 17, 2017 Hi Do not " connect the remote on/off switch to pins 2 6 7 " Stop/start switch you connect to 6 & 2 Yes you can take an audio out feed from 3 (signal) and 7 (ground) mike Quote Link to comment Share on other sites More sharing options...
MarkC Posted April 17, 2017 Author Report Share Posted April 17, 2017 Thanks Mike, I really appreciate it! MarkC Quote Link to comment Share on other sites More sharing options...
MarkC Posted May 26, 2017 Author Report Share Posted May 26, 2017 FWIW I made a three way connector cable to operate output, input and start stop today and it works flawlessly. Thanks Mike, your advice was exactly what I needed. Thanks everyone Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.