chris_bollard Posted July 6, 2017 Report Share Posted July 6, 2017 Does anyone here know the make of the SMA Connector that Lectro uses for their transmitter antennas? Quote Link to comment Share on other sites More sharing options...
mikewest Posted July 6, 2017 Report Share Posted July 6, 2017 Have a look on eBay Plenty of surprises there like 2 x HD-25 leads at $20 no postage? mike Quote Link to comment Share on other sites More sharing options...
chris_bollard Posted July 7, 2017 Author Report Share Posted July 7, 2017 Sorry but that makes absolutely no sense.... Quote Link to comment Share on other sites More sharing options...
mikewest Posted July 8, 2017 Report Share Posted July 8, 2017 Sorry Chris, thought it was a clear message Look on eBay Connector SMA Male Plug Cable Straight.doc Quote Link to comment Share on other sites More sharing options...
chris_bollard Posted July 8, 2017 Author Report Share Posted July 8, 2017 Thanks Mike, but I am looking for the type of connector that Lectro uses for their Transmitter antennas. The centre pin is solder and there is a compression rubber grommet that locks the cable in place. Quote Link to comment Share on other sites More sharing options...
ducky Posted July 8, 2017 Report Share Posted July 8, 2017 Hi Chris. Sounds like you're describing the dielectric material present in 50ohm coax cable and SMA terminations. Any 50ohm SMA cable should suit your needs. If you're after a replacement whip antenna, there are plenty online. Stick to 50ohms, trim it to the appropriate frequency and you'll be fine Mate. Quote Link to comment Share on other sites More sharing options...
Constantin Posted July 8, 2017 Report Share Posted July 8, 2017 This is not the Lectro connector, but maybe it'll work too:https://www.ebay.de/itm/222519971735 Quote Link to comment Share on other sites More sharing options...
Freeheel Posted July 11, 2017 Report Share Posted July 11, 2017 I'm going to go all senatorial and suggest you phone Lectrosonics. Cheers, Brent Calkin Quote Link to comment Share on other sites More sharing options...
LarryF Posted July 11, 2017 Report Share Posted July 11, 2017 On 7/8/2017 at 6:44 AM, chris_bollard said: Thanks Mike, but I am looking for the type of connector that Lectro uses for their Transmitter antennas. The centre pin is solder and there is a compression rubber grommet that locks the cable in place. Hi Chris, That's a custom connector made by us with the compression o ring. Call service for the part. Best, Larryf Quote Link to comment Share on other sites More sharing options...
chris_bollard Posted July 12, 2017 Author Report Share Posted July 12, 2017 Hi Larry Thanks for the clarification. The BEST connector for the job and nothing else in the market that comes close. Quote Link to comment Share on other sites More sharing options...
Freeheel Posted July 14, 2017 Report Share Posted July 14, 2017 OK, so maybe you don't have to phone Lectro, since Larry is still making house calls... Cheers, Brent Calkin Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.