Jump to content

Robert Buncher

Members
  • Posts

    167
  • Joined

  • Last visited

Posts posted by Robert Buncher

  1. I'm going to be working around one of these Robo Cams next week, Sony BRC-H900 recording to a PIX 240. I'll be running three talent wires and sending wireless scratch to the Pix and also to another camera so I'm concerned about RF from the remote control.  Does anyone have any more information at what frequencies these are spitting out RF? I see Wandering Ear's scan is in the lower 600s.

    Thanks. Bob

  2. Thanks for the replies on this.

     

    All my lavs either work or don't work so I could not go that route. Instead I picked up a short Beyer Dynamic gooseneck mic on Ebay for $20 and that is working just fine. I put it in the battery pocket of the Petrol with the mic just sticking out.

  3. Thanks Pierre,

     

    My concern was sending an unbalanced signal into a balanced input. Up until now I had been sending just an audio signal from a G2 to the BMC. I would jump the shield and ring on the G2 1/8 and connect them to the shield on the BMC 1/4 and then connect the G2 tip to the BMC tip. This works fine.

     

    It seems my option with sending both TC and audio is possibly:

    TIG 1/8         to      BMC 1/4 x2

    Shield           to      Shield Left and Right

    Tip (TC)         to      Tip Left (TC)

    Ring (Audio)  to      Ring Right (Audio)

     

    I'll try this but I think there will be the problem of unbalance into balanced.

    Bob

  4. I need to make a cable to send time code and audio from a TIG to a Blackmagic camera. So the BMC has two 1/4 inputs which are balanced. I want to send the TC to one channel and audio to the other channel. I'll be splitting these from the 1/8 connector. How would I wire this?

    Thanks,

    Bob

×
×
  • Create New...