Jump to content

JenceF

Members
  • Content Count

    27
  • Joined

  • Last visited

About JenceF

  • Rank
    Member
  • Birthday 02/09/1990

Profile Information

  • Location
    Norway
  • Interested in Sound for Picture
    Yes
  • About
    Location recording, post production, sound design

Recent Profile Visitors

1,894 profile views
  1. JenceF

    DIY- Right Angle XLRs

    Here’s some illustrations of how it assembles. Seems like the strain relief is just a hole to pass the cable.
  2. JenceF

    Zoom F8n.

  3. JenceF

    Wisycom Tx + UMP II (Ambient) ??

    Where is the microdot? You should check this out: https://wisycom.com/products/product/pha48/
  4. JenceF

    Wireless

    What is this? Try them out. Find out What works for you. And don't belive anything you read on the internet
  5. JenceF

    Stolen SD 688

    So happy for you RD! Too bad about the missing pieces but i would call it a victory. Would love to hear how you went about getting your stuff back and who was involved if you're at liberty to tell.
  6. JenceF

    Cheapo boom pole

    At least he's not giving them the brush-off. What is the current day rate for an experiencend broom op these days?
  7. JenceF

    Norway Rental

    @BryanRobson Greetings from Oslo! I don't think you'll have any problem finding free space within block 606 over here. And you don't need a licence.
  8. JenceF

    New Boom Pole at CineGear

    +1 regarding foam. Any information about length and weight?
  9. JenceF

    Defective Mic?

    http://www.factcheck.org/2016/06/clintons-1975-rape-case/
  10. JenceF

    Zoom F8 extended knobs

    @KISHOR CHAUHAN How are those knobs attached?
  11. JenceF

    Zoom F8

    I've never had any pre-roll issues on v2.0. What's the issue like? I am using Sandisk extreme plus 80 MB/s. Don't think it's officially supported but it passes both tests and so far no card related issues.
  12. JenceF

    Zoom F8

    I would say there were only one right and several wrong TC settings. Not some settings being less stable. But considering the relatively little amount of offset my guess would be the lack of internal battery to run the TC when shut down and the operator not knowing about this "feature".
  13. JenceF

    Senn G3 as camera hop, a wiring question

    The link seems to be dead. I'm making a standard TRS jack to summed G3 line level input. Have any of you had any luck with this wiring without any in line pading? Standard stereo source: Tip - hot Ring - cold Sleeve - ground G3 line input: Tip - ground Ring - hot+cold Sleeve - ground
  14. JenceF

    Zoom F8

    I would guess the timecode was going on the RTC each time the unit was shut down. That would cause it to drift seconds out of time through the day.
  15. JenceF

    Zoom F8

    @Koca what kind of battery did you use? And what voltage?
×