Geluidloopt

My bad! Thought I read you were using a ZMT3

The distortion with the 6060 (or 4060,4061,...) is due to the fact that there is powering mismatch between the 5v DPA mics and 3V transmitters. The only dpa mic that will adhere those spl specs in combination with a Zaxcom tx (pre ZMT4 of course) is the 4063.

Good point

Www.b9audio.com lawsuit waiting to happen!

A Sonosax m2d2 to a zaxcom trx743 with an AES cone is hard to beat!

My Altec VOTTs (Voice of the Theatre), great sound on half a Watt!

Hi, The neutrik part is : https://www.neutrik.com/en/product/nc3fx-spec However it screws in a custom ring i built, ie the black cone part in the picture. This allows easy replacement of the connector when it's worn.

On top of the pole

Neutrik Locking XLR straight onto the mic mount

B-format is set to ON

Normal is 32khz sampling rate, ursa wants to see 48khz and has no src. That’s why it’s not working

So sad to hear. A great loss

I wouldn't worry about it

I had the same problem, where my 4 QRXs introduced a low-level high pitched whine into my Sonosax mixer, not unlike what an IFB100 used to produce when on the same power supply. I believe at one point I even had the grounds (pin1) disconnected entirely, and this removed all of the noise, however this may have been specific for my cart/setup, and maybe not a very safe solution, for the equipment. I recently switched to an RX12, and have since had zero problems (pin1 connected).

Ground Lift worked for me

Nice!

Hi Rado, Did you do this on 5.23 or on 6.00? i am not able to get the nomad into the state described in the instructions, running 6.00

+1 for full Zaxnet integration

Hey, i'm doing a show with 3 of these EX-3s and our modus operandi is a lockit on each camera, 25fps (thank you PAL-world!) and it syncs up perfectly, no complaints from post! I haven't tried jamming them to check the drift, so can't really say anything about that. They have all the regular tc frame-rates, so no varicam cross-jam weirdness here! greetings Marijn

I'm personally using the cinela Osix 2 mount for my Schoeps and i must say i'm very happy with it, after always having boomed with a rycote suspension. It is much quieter, handling wise, and the price is not that bad here in europe... although more fragile. in regards to the cut1, i've never used or felt the need for one; especially with the cinela mount, the highpass on my SD 442 seems to be fine. Marijn

any exact data on when this is coming out? cause i was going for a 744T for a doc next month, but this looks very promising...