Thank you for your help. I just got it going.
Global Configurator application is not required....much easier to configure with the units web interface.
-It is very likely your unit won't have the default IP address. Read the user manual to reset. (hold reset button process)
-Log into the web interface by entering IP address into browser. (default 192.168.254.254) You will have to change IP address of your computer to 192.168.254.### to be able to log in.
-Change IP address of the Extron unit to work on your network.
-Change your computer back to automatic IP address
-Log back into web interface by entering your new Extron IP address.
-Click on Port Settings tab
-Change each port to have settings:
Port Type: RS232
Baud Rate: 57600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Open Wireless Designer
-Connect via Network
-enter IP address of Extron
and the magic Port numbers are: (4 channel version)
2001
2002
2003
2004
Good luck
Does anyone have any experience in setting this up?
I have an Extron IPL T S4 connected to 4 x Lectro Venue 1 (Wideband Mid).
I have installed Extron Global Configurator 3.
I am at a loss at what to do next.
Thank you in advance.
Has anyone tried any of the products from RF-Links?
GX-68
I've been wondering if I could use a GX-68 and take an output of of my antenna distro to send to one of their receivers. It's analogue, but I'm not fussed with quality, just need to see which talent is in front of the camera in reality TV.
It would be an expensive experiment...
Thanks Larry and Karl,
Understood!
I generally have 6 Venues in a rack, so would help to tidy up and provide more reliability.
I also have a rack of 8 x IFBT4 which could benefit from this.
Thank you, fantastic looking product.
I struggled with this problem with many of my SM transmitters. I found that the spring washer was grinding a circle off the coating on the battery door. If you remove the circlip and flip the spring washer upside-down you will get extra life out of the battery door. I work in very dusty environments and now as a matter of course blow canned air under the spring washer with the battery door off the transmitter, to remove grinding particles. Give it a try...