-
Posts
185 -
Joined
-
Last visited
Content Type
Forums
Gallery
Store
Posts posted by CraigF
-
-
a right angle/better cable clamp for the 10 pins would be a big win
-
hot glue work as well, heat gun to melt it off
-
-
Got an Oktava to test, put it in the anechoic chamber, the POS had better frequency response off-axis than it did on axis.
-
PT 12.3 update preview https://www.youtube.com/watch?v=SN4nji4XetY
-
I'm late to this but maybe some contact mics on some of the trusses, wood tends to creak and groan
-
dam B&W photo making it look vintage
-
Then, was Landis qualified to continue directing films after Twilight Zone ?
would the internet let him today?
-
Try and get a tour of Universal's Foley Stage
Or just tell the contractor to copy their stage
-
you would have to send the s/n to Sennheiser to get age and if it's a fake or not.
There should not be any RF issues if the set screw is not missing
-
I world say yes but start with 1 http://www.trewaudio.com/store/PSC-48V-Phantom-to-12V-T-Power-Barrel-Adapter.html
are there spots of red paint on them for Red Dot? if so you will need a cable that flips pins 2 & 3 between the converter and the mic
a 816, converter barrel and custom Rt. Angle XLR will just fit in the Rycote for the 815/6
-
any of these work for you|
-
it's something like a 5µH inductor if I remember correctly
-
Bass Management is part of the room's B-Chain calibration
Using a software option presents the possibility of shipping files that have it baked into the files
-
Am I thinking about this the wrong way?
yes, you are think the wrong way
what you need is band limited pink, pink nose with HP at 500 and LP at 2000 (aka Dolby Pink) this helps eliminate room modes from effecting the measurement level
so 1 channel set to 1 output, SG set to -20dB Pink, EQ3 with LPF set to 500 & HPF set to 2k
measure the SPL for that channel, trim to 85 dB slow C
change the output for the next speaker
repeat
setting the SG to 0 would make you calibration 20 dB to low / you mixes would be ~20 dB low
-
Micah, I didn't make that video. I just found it and thought it might help a few prople
-
because who doesn't like free?
http://goo.gl/K58hvn -
-
Belden 1804A, I can not sing it's praises enough
-
given that it's all compressed, I hope not
I hope this idea dies on the vine
-
Isn't enough the 300+ dollars (equipment rent) per day to clean your equipment? I'm trying to understand the logic behind this decision.
it should be for an average job
but a 1 day job subjugated to a sand storm or salt water spray where all the gear need to be opened up (not just dusted off), no
-
It should be OK, it is dependent on the impedance and capacitance of the cable in question
if it's something you're going to do regularly I'd recommend getting some AES cables
-
Doug that should go onto Movie Set Memes
-
a door sign can help also
Maybe Dave would run a patch of Sound People ones
searching for potentiometer Knobs
in Do It Yourself
Posted
http://apexelectronic.com/KN9-W-6A
or
http://apexelectronic.com/KN13-W-6A