Hi all,
I´ve been reading several posts related to my issue being a 2013 post the closer to shred some light into it. Still I´m not sure what is wrong/what I should do.
I bought a dpa 4062 to be used with my smqv but it came with lemo. I switched (not myself) the connector a ta5 and when used with the smqv I have to bump it up to around 35 /40 for normal speech dialogue. The real issue is that at this level there is a huge amount of hiss, and even though it is a low sens mic I believe it is way too much. I was told a 4k resistor was fitted with the ta5 and from what I´ve read I have understood this is way too much.
Is this fixable with a lower resistance or is the 4062 not intended for normal speech at all? If so, what would be the recommended ohms on the resistance?
Thanks!
PD: Not really related but is there a way to distinguish 4060s from 4061s and 4062s just by the sight of them?