Jump to content

Help with a BNC connector


MatthewFreedAudio
 Share

Recommended Posts

I'm assembling a few cables and I can't figure out how the circular backing plate goes on the BNC connector. It's just the little plate to close off the opening. It doesn't screw in, I can't get it to pop in and lock, and it doesn't appear to be crimped, soldered, or pounded into place. Any ideas as to how it goes in?

I'll post a photo I snapped with my phone.

www.matthewfreed.com

Production Sound Mixing for TV, Films, and Commercials

post-2218-132832834318.jpg

Link to comment
Share on other sites

L-Com didn't say much on Saturday, February 4th when I was making the cables and had a question about the connector. I suppose I could have waited until Monday, but I had a gig all day long...same for Tuesday.

Damn...I wish there was another source of information other than the reseller of a product...if only there was a knowledge base somewhere I could pose a question to knowlegable people in a similar line of work who may have previously come across the same issue...

www.matthewfreed.com

Production Sound Mixing for TV, Films, and Commercials

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...