Jump to content

Sebastian

Recommended Posts

Hi guys

 

Just needing a little assistance regarding the cable techniques Rx emergency unit which I recently bought. I'm finding the noise floor extremely high and I'm sure that shouldn't be the case. I'm using a Lectro 411a, outputting line level @ 0dBu from the receiver into the mix in of my 302. I'm getting decent audio levels but the hiss is bad. I've tried it on my other 411a with the same results. The one possible cause I thought of could be the balanced cable which I wired myself, however from an XLR to TA3F the wiring is straight forward 1 to 1, 2 to 2 and 3 to 3. Unless I need to add a resistor somewhere.

 

Any help would be appreciated!

 

Sebastian

Link to comment
Share on other sites

i am guessing you are using the mix in input of of your 302. it is wired 1 ground, 2 left, 3 right. and the shell of the connector must be connected to pin 1.

 

you could also try using the return input with the appropriate setting in the menu.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...