soundmanjohn Posted May 6, 2014 Report Share Posted May 6, 2014 As promised: Two circuits: the first for unbalanced 9v operation, the second (which is what's inside the DPA 6001 adapter) for balanced 48v Phantom operation. Best to check with a mic you don't mind losing if you're not sure about construction. Don't blame me if it all goes wrong! Regards, Quote Link to comment Share on other sites More sharing options...
iggipopovski Posted May 8, 2014 Report Share Posted May 8, 2014 15 minutes of DIY, checked and everything seems fine. I've compared with original DAD 6001, both sounds equal. Thanks Quote Link to comment Share on other sites More sharing options...
Erkal Taskin Posted April 26, 2015 Report Share Posted April 26, 2015 15 minutes of DIY, checked and everything seems fine. I've compared with original DAD 6001, both sounds equal. Thanks Hey if you made the above, could you post a photo please? Quote Link to comment Share on other sites More sharing options...
LuckyNat Posted December 1, 2018 Report Share Posted December 1, 2018 Thanks to finding these schematics from Soundmanjon, I'm going to build a couple of circuits to power my ex-theatre DPA 4061s.. (both cut at the wire..) A small question before I do so: My recorder can give 12V Tpower. Will adjusting the circuit above for T-Power and making an adapter for T-power instead, save me recorder battery? If T and phantom both have same current draw, I'd guess that would be correct.. ? Quote Link to comment Share on other sites More sharing options...
lstanislawski Posted April 2, 2019 Report Share Posted April 2, 2019 Sorry for digging topic up. What types of capacitors use in this build? Quote Link to comment Share on other sites More sharing options...
drpro Posted April 2, 2019 Report Share Posted April 2, 2019 If you are using discrete components, take a look at the Elna Silmic II. Really nice for the cost of a 50v 10uf is about .70usd. Plus it has "mic" in the name. Quote Link to comment Share on other sites More sharing options...
stellar Posted April 6, 2022 Report Share Posted April 6, 2022 Few years late but please on the 9 volt battery schematics The 10uF capacitor has no polarity shown. Is it electrolytic and polarity is not showing or non polarized polypropylene ? If anyone built this power supply please could you comment on my question. Thanks Stellar Quote Link to comment Share on other sites More sharing options...
soundmanjohn Posted May 28, 2022 Author Report Share Posted May 28, 2022 On 4/6/2022 at 7:15 PM, stellar said: Is it electrolytic and polarity is not showing or non polarized polypropylene ? It's non-polarized. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.