Bash Posted October 4, 2015 Report Share Posted October 4, 2015 (edited) I've been writing reviews for quite a long time, in various magazines, so I just love doing shoot-outs. So here's a couple of sound clips comparing the AVX system with a Sennheiser 2000 system etcetera. The signal-path is a DPA 4017B shotgun mic -> SD664 with low-cut at 80Hz -> cable / AVX / SK_EK 2000 / G3 -> Antelope Pure2 ADC at 48kHz. As you can hear in one of the sound clips, AVX is level sensitive and not at all as 'smart' as I thought it would be. To me it sounds like it pretty much has a set Threshold where it starts compressing excessive input level. I've set the outputs from my mixer to -10 which is fine for the SK2000 and the G3 transmitters I normally use as camera link. In comparison the output to the AVX transmitter had to be attenuated 20dB more, otherwise the internal compressor stomped down the level. Let me know what you think okay. And thanks for putting up with my voice and my English. :-) Cheers Fred Hi Fred, are you aware of the IP thing on G3, and does AVX do the same thing - on a tip ring sleeve 3.5mm plug, going into a G3 transmitter, one out of the tip and ring (I cant remember off hand) is unbalanced mic level, and the other is unbalanced line level, if I recall correctly. So - when you say 10db attenuation, plus another 20dB attenuation.... might you have been using the regular dynamic mic IP lead, rather than a line level IP lead, hence you had to pad down so much? Kindest regards, Simon B Edited October 4, 2015 by Bash clarity Quote Link to comment Share on other sites More sharing options...
Bob K Posted October 14, 2015 Report Share Posted October 14, 2015 ninjafreddan: "my solution has been to use a hirose to USB connection and then power it via a USB connection." Do you mean to say you're taking power from the camera's 12V hirose output and connecting it to the 3.7V receivers? If so, is that a custom cable? Quote Link to comment Share on other sites More sharing options...
Lauri Laagus Posted October 15, 2015 Report Share Posted October 15, 2015 Hi. I did the comparison test between AVX and cable connection for camera hop. I sent test tone from SD633 to computer and got these results. AVX adds lot of harmonics to the signal. Quote Link to comment Share on other sites More sharing options...
BennoZ Posted September 16, 2019 Report Share Posted September 16, 2019 Sennheiser tells me the following: "The SK-AVX (bodypack) has NO line input, in contrast to our EW series (SK100 / 300 / 500G4). Only microphone!" But the manual says it can??? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.