Jump to content

RME Arc / Totalmix and surround monitoring.


Dan Rossi

Recommended Posts

I am trying to move to using RME Totalmix directly for surround monitoring control with the RME Arc controller. Has anyone figured out a good configuration for this ?

It seems much better in quality just connecting the monitors directly rather than using a hardware controller. 

I managed to get a mute group working for all outputs and a button toggles this. The volume dial can be used to control a fader group for all outputs with a recall for calibrated level. 

My issue so far I am trying to figure out. When I power on the speakers with the power conditioner there is now a loud pop, I could avoid having mute on the SPL active. I am trying to address this without having to turn each Genelec off now. 

Attatched is a screen shot of partial Totalmix setup I am working on. The blue buttons is the chained mute groups. A button is mapped to toggling that mute group. 


Let me know. 

44323459_10156622102250168_673983190259466240_n.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...