Brain89 Posted November 13, 2019 Report Share Posted November 13, 2019 I am somewhat new to lectrosonics but I bought these used and I cannot get them to pair. I have scanned frequencies with the receiver and I know they're both on the correct frequency. Compatibility is on 400 Is there something I am doing wrong? Quote Link to comment Share on other sites More sharing options...
ProSound Posted November 13, 2019 Report Share Posted November 13, 2019 You set both to the same frequency and that is it; Lectrosonics support is great too call them up https://www.lectrosonics.com/Service-Repair/ Quote Link to comment Share on other sites More sharing options...
DonovanBomb Posted November 13, 2019 Report Share Posted November 13, 2019 Turning the power on? Ah, I'm joking with yah. Your pic isn't giving us too much information to work with. Show us the sides or a pic of the units on the same frequency. There's people in this forum who could tell you absolutely everything about these units with just a serial number. Quote Link to comment Share on other sites More sharing options...
WesH Posted November 13, 2019 Report Share Posted November 13, 2019 Since you reference SMV L, not a specific block, please ensure both are listed as the same block. If one unit is block 470 and the other is block 19, there is a possibility that they are set to the same frequency (for example, 487.000 is available in both block 470 and block 19) but will have different pilot tones and therefore not pair properly. If this is the case, you can make them work together by turning off the pilot tone. Best, Wes Herron -- Lectrosonics Quote Link to comment Share on other sites More sharing options...
Brain89 Posted November 14, 2019 Author Report Share Posted November 14, 2019 Sorry for the delay. Quote Link to comment Share on other sites More sharing options...
G Murphy Posted November 14, 2019 Report Share Posted November 14, 2019 Since the SMV is set to 400 mode, check that the compatibility mode is set to "Hybrid" or "NA 400" on your 411a receiver. Link here: UCR411a Manual Quote Link to comment Share on other sites More sharing options...
Brain89 Posted November 15, 2019 Author Report Share Posted November 15, 2019 Yeah so it was 400 on both and when I called lectrosonics they had me bypass the pilot tone to try and get them to pair. When we did this the receiver just. When sending whitenoise into the recorder. I tried a few different channels and nothing changed. Just decided to send it in. Seemed like it would be the wise call to make. Quote Link to comment Share on other sites More sharing options...
karlw Posted November 15, 2019 Report Share Posted November 15, 2019 Just making sure you have the transmitter all the way on to transmit (turn on by holding AUDIO and FREQ buttons for 3 seconds - you'll see the count-up). If in RF OFF mode, it should say that in the display. Do you have access to any other Block 21 transmitters or receivers to isolate the problem to one or the other unit? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.