Jump to content

6-Series v4.61 Now Available!


Johnny Karlsson

Recommended Posts

I'm disappointed to report that X1 / X2 still reset themselves to "off", when auto-mute is engaged, and thus will not pass any audio while rolling.

This reset happens after power cycling the 633 (seems to hold fine while Quickstart is still keeping the blue TC light blinking, but not if holding the Menu button for 6 sec to shut down completely).

The workaround is to go to the AUX screen and use the select knob to turn it back up... but the next time you boot up or load a preset with Auto Mute, you have to remember to go in and manually turn them back up.

 

- I did start from factory settings. I actually loaded factory settings before running the firmware update. Even set all four presets to factory defaults before loading the firmware - a second time. Then tested again with all factory default settings, except setting AUX 1 + 2 to L + R and Auto Mute.

 

 

 

 

Link to comment
Share on other sites

12 minutes ago, Johnny Karlsson said:

This reset happens after power cycling the 633 (seems to hold fine while Quickstart is still keeping the blue TC light blinking, but not if holding the Menu button for 6 sec to shut down completely).


So when you turn it off normally the setting stays as well? What about when the blue light stops blinking? Is the setting lost then as well?

Link to comment
Share on other sites

4 hours ago, Constantin said:


So when you turn it off normally the setting stays as well? What about when the blue light stops blinking? Is the setting lost then as well?

 

If I had to take a guess, I would say it probably will reset to off, since that would essentially be the same thing as holding the menu button, letting go of TC and quick-start.

 

But hey, why not - I will try that now. I‘ll wait until the blue light stops blinking, then check and  report back here.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...