Wiring Shure DL4 lav on Zaxcom trx

[joinwooHK]

i got a new DL4 Lemo , seems it is balanced wiring , so i cant get audio with Zaxcom Trx .Would anyone advise what i can do to get the audio
Typical Wiring Table

Series	Cable Construction	Electrical Design	Polarity	Replacement Connector	For Use With	Wiring	Line Art (From Solder Side)
DL4-LEMO	1.6mm cable with single conductor and shield	3 wire with additional bias on pin 3	Positive with respect to ground	WA416	Shure Lemo Bodypacks (AD1/ADX1-Lemo, Shure UR1M-Lemo, ULXD1-Lemo)	Red wire: Audio/Bias(2) Blue wire: Audio(3 Shield: Ground(1)
DL4-MTQG	1.6mm cable with 2 conductors, 2 shield wires and shield	3-Wire	Positive with respect to ground	WA430	All Shure TA4F Bodypacks	Red wire: Bias(2) Blue wire: Audio(3) Shield wire: Ground(1) Shield: Ground (Shell)

[Rick Reineke]

Contact Shure and/or Zaxcom for a wiring diagram. Most lavs are not balanced, The third wire, if there is one, is for bias voltage. If it has an XLR connection, it is balanced in the transformer/power supply module.

btw, soldering a Lemo is challenging... at least for me.

[rich]

ive never tried wiring this mic, but from comparing a COS11 which has an audio and bias wire, 

my first try would be to connect blue and shield to pin 1 and red to pin 3

 

though i would at least solder the blue and shield together and prep the red wire, then place the solder insert into a powered up transmitter as it would if it had the outer shell, then touch the cables to pins 1 and 3. if you can hear audio, solder it up and assemble it.

if it doesnt work, try with blue to pin 3 and red tied to shield and pin 1.