thope Posted February 5, 2021 Report Share Posted February 5, 2021 Hi Guys, Has anyone experienced any issues with a CMIT into a Lectrosonics HM? I used a friends CMIT for a film a couple of years ago and loved it. I finally bought my own one but can't get it to play with my HM plug on. There is no level out of it until I set the TX to 55 (max) and then its terrible and unusable, with hiss and noise. It works fine cabled into my recorder. Is there some grounding issue here? My friends CMIT worked fine with the same transmitter. Any help would be appreciated. Trev Quote Link to comment Share on other sites More sharing options...
r.paterson Posted February 5, 2021 Report Share Posted February 5, 2021 Hm set to 15v not 48v? Or HM not outputting full 48v? Quote Link to comment Share on other sites More sharing options...
John Blankenship Posted February 5, 2021 Report Share Posted February 5, 2021 See if a phase reverse barrel (or cable) between the mic and the HM makes any difference. Quote Link to comment Share on other sites More sharing options...
LarryF Posted February 5, 2021 Report Share Posted February 5, 2021 22 minutes ago, John Blankenship said: See if a phase reverse barrel (or cable) between the mic and the HM makes any difference. +1. Also check with Lectro service. I'm sure they have run into this before. Best Regards, Larry Fisher Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.