Jump to content

Recommended Posts

As I recall for the SK-100 bodypack transmitter,  on most three wire lavs (audio, bias and ground/shield) both the audio and bias current wires go to the Tip. Cable shield to Ring and Sleeve. I have 2 AT-899s, but they are wired to a TA-5 (Lectro) plug. Both have stiff cables, so I never use them. They are old and later builds allegedly have softer,  more flexible cable.

Link to post
Share on other sites
1 hour ago, Rick Reineke said:

As I recall, on three wire lav, both the audio and bias current wires go to the Tip. Cable shield to Ring and Sleeve. I have 2 AT-899s, but they are wired to a TA-5 (Lectro) plug. Both have stiff cables, so I never use them,

Rick, I believe you are right. I found this diagram on the Sennheiser site. So if the center picture is correct, Mic and Bias to tip Ring and Sleeve tied to ground.

EW%20Plug%20Wiring%20Pin%20Out.png

 

 

42 minutes ago, Jim Feeley said:

No reasons to challenge Rick, but Michael maybe contact AT's US office which appears to be just down the road from you:

 

https://www.audio-technica.com/en-us/contact

 

 

Good idea but I already asked them about the pin outs and they supplied me the info for the AT899.

The marketing director at AT and I were both in each other's wedding parties. Our sons are best friends.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...