Search the Community
Showing results for tags 'UCR211'.
-
Hello hive mind, seems like I´m going through a rough patch with my gear lately :/ (i recently had problems with my 633 too ... ) One of my UCR211 has non responsive up/down buttons, I can´t select a new frequency and/or change any setup settings. Strangely enough it will go into freq scan mode but instead of all three i can get into it only pressing one of the up/down and the menu button.. Any ideas how to fix this? Thanks!
-
Hi All, First time poster long time reader. I have just bought my first Lectros- used 211/200c, three sets. I did a search of the forum, but couldn't quite find the issue I'm having. Search functionality was good though Here's what I'm doing, and the issue I'm having- hopefully someone can help me diagnose the problem. 211/200c w/ Countryman B3 (hot mic, extra crisp cap) into SD664. There's a noise/hiss which occurrs in unison with the syllables of dialogue/all transient sounds. The noise almost seems to 'gate', in the sense that it will only be audible with the passing of dialogue/transients. Very high end hiss/noise. I had this problem years ago in film school with some cheap Sony wireless, it was impossible to EQ out, it seemed as though the more top end you roll off, you just hear the noise in the middle of the spectrum. The level of the noise is not above the dialogue, it's well and truly 'back there' in the mix, but it's obviously there. The only thread I found which came close to this symptom was one regarding a compander issue where the entire program content was 'gating'... however this is not the case for me, it's simply the noise which gates in and out. It happens with all three Rx/Tx sets. I have only two Countryman B3s, and it's possible that one of the mics is less noiser than the other, but only slightly. Could it be an issue with Mic wiring? Or are my Lectros in need of a service? I don't think it's a gain structure issue, but will be very happily proved wrong. I've also switched out my leads running from Rx to 664, no change. Batteries are new and full 9V Duracell Procell (non rechargable). I am in Australia, the units came to me from Singapore, and are not the AU models. Help me Obi Wan Kenobi, you're my only hope. Cheers to all, and apologies to anyone who finds this topic has already been covered here. Travis Williamson
-
Title says it all. I'm looking to put together a new camera hop rig and need one more receiver.
- 1 reply
-
- Lectrosonics
- Ucr201
-
(and 3 more)
Tagged with: