Rawturnip Posted February 7, 2018 Report Posted February 7, 2018 I have a SD 633 and want to run a Micron Explorer receiver into the line in TA3 on channels 4,5,or 6. Can I just re-terminate the Micron output cable (RX AOCH-HR4......just signal, no power) to a TA3. I've noticed the Micron cable has a "ground Jumper"; a TA3 can't be wired the same. Any thoughts? Quote
daniel Posted February 7, 2018 Report Posted February 7, 2018 I have no idea but there's a good chance these guys can tell you: http://www.micronwireless.co.uk/ Quote
Mark LeBlanc Posted February 7, 2018 Report Posted February 7, 2018 Yes. If all you are doing is swapping out the full size XLR to TA3 there are no special things u need to do. Just match the wiring from the XLR to the TA3 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.