ncsoundmixer Posted April 27, 2012 Report Share Posted April 27, 2012 I want to use the internal mic to talk down Headphone 2 to my boom op via the "Com" button while leaving the "Slate" function out of the equation. I looked in the routing bus menus and could not find a dedicated Com matrix that would allow me to press Com and talk only to the boom op through Headphone 2. Quote Link to comment Share on other sites More sharing options...
John Blankenship Posted April 27, 2012 Report Share Posted April 27, 2012 I think you'd need to route it to an unused output buss and then route that to headphone 2. Quote Link to comment Share on other sites More sharing options...
Ryan Coomer Posted April 27, 2012 Report Share Posted April 27, 2012 If you press the BUS membrane button while on the first OUTPUT BUS ASSIGN routing page, it will take you to another screen that will allow you to route it to any of the 6 busses. Then, route that bus only to HP2. Quote Link to comment Share on other sites More sharing options...
ncsoundmixer Posted April 27, 2012 Author Report Share Posted April 27, 2012 The Aux Inputs page only allows one to assign Returns, Slate, and Com to output busses, not directly to Headphone 2. I'm looking for a way to directly route Com to Headphone 2 without involving/affecting output busses. I have followed your advice and set Out 6 for Com and included it with the boom input on Headphone 2. Thanx. Quote Link to comment Share on other sites More sharing options...
Jack Norflus Posted April 27, 2012 Report Share Posted April 27, 2012 At this point you can't direct route slate and com to HP2. If I recall correctly I believe this is slated to added. Quote Link to comment Share on other sites More sharing options...
Wandering Ear Posted April 28, 2012 Report Share Posted April 28, 2012 At this point you can't direct route slate and com to HP2. If I recall correctly I believe this is slated to added. Although I haven't needed it yet, using outputs works fine, it would be nice to have. Wandering Ear Quote Link to comment Share on other sites More sharing options...
ccsnd Posted April 28, 2012 Report Share Posted April 28, 2012 I have my com set to output 6 (that is the only thing on 6) and output 6 going to HP2. Right now, dedicating an output is the only way to do it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.