-
Posts
164 -
Joined
-
Last visited
About Jesse Watts
- Birthday 10/24/1982
Profile Information
-
Location
Los Angeles
-
About
Production Sound Mixer; Commercial, Film, TV
Recent Profile Visitors
3,183 profile views
-
Sound Devices 688 external slate mic *low gain?
Jesse Watts replied to Jesse Watts's topic in Equipment
Tom, Yea, its considerably lower than my 664 and my 633. I called them and they said they would look into it. Maybe a few more owners should let them know about it. -
Jesse Watts changed their profile photo
-
-
It's quite easy to re-wire a ta-5. it just requires a good iron and a steady hand.
-
Sound Devices 688 external slate mic *low gain?
Jesse Watts replied to Jesse Watts's topic in Equipment
Yea I just tested it on my 664 and have a little boost over the 688 but not much. Maybe firmware? It might be a hardware limitation, a silly mistake if that's the case. My 788t has a ton of boost but then again it's routed through a mic pre. -
So I'm dialing in my new 688 and have found the gain to be very weak on the ext slate mic in. Has anyone else experienced this? I have tried a Sennheiser Me2 condenser and a Sure Dynamic lav on max gain (+36) with the same results. I get good level at mouth distance but not at my typical 2ft ish for slating.
-
Kit Questions about customs moving to Europe
Jesse Watts replied to Jesse Watts's topic in General Discussion
Thanks for all the info Robert, much appreciated. Btw randomly found you on soundrolling, good stuff ;-) Cheers, Jesse -
Kit Questions about customs moving to Europe
Jesse Watts replied to Jesse Watts's topic in General Discussion
Did you have to make an itemised list and show purchase receipts? thanks for the info! -
Kit Questions about customs moving to Europe
Jesse Watts replied to Jesse Watts's topic in General Discussion
I'm definitely going to look into that . Seems like the way to go. Thanks! -
So I am moving to Spain in the near future and am hoping to get some insight from someone who may have done this already. I will be shrinking my kit quite a bit for the move (most if not all in a pelican 1650) *Goodies in FS section soon :-) My plan is to check the kit but whats the best way to navigate customs and avoid getting reamed? Thanks! Jesse
-
Reminds me of à gréât vidéo. http://m.youtube.com/watch?v=sFu9_b-BsIs
-
Quentin Tarantino on set Cell Phone Ban
Jesse Watts replied to Jesse Watts's topic in General Discussion
Here is some of his on set classic slate shenanigans. http://youtu.be/195DIZY-C3Y -
Very true. In my small circle of mixer buddies we naturally swap jobs when we're overwhelmed. It requires some trust and respect if that second call comes your way. And yes, This has become my only sound forum I participate in because of the knowledge and experience all you guys and gals bring. Keeps my head in the game during the slow weeks... like now :-( Thanks Jeff
-
Quentin Tarantino on set Cell Phone Ban
Jesse Watts replied to Jesse Watts's topic in General Discussion
They could call it the Tarantino Act of 2013 -
http://youtu.be/EkmhWcfCn9I Just stumbled across this. It made me like Quentin even more. Wish most sets would implement this.
-
I dig the setup but am curious what you gain over the factory whips? I kinda get using an antenna distro in a bag with sharkfins because you gain the directional advantage of the fins. Isn't this two steps forward and one step back?